Sharp UP-3301 Manuale Utente

INSTALLATION MANUALCODE : 00ZqCONTENTSParts marked with "!" are important for maintaining the safety of the set. Be sure to replace these pa

UP-3301V Built-in Printer: UP-T80BP– 8 –10) Fastening onthe table: Secure the Base cabinet 2 using the screw.Lowering the height of the UP-P16DPRemove

UP-3301V Built-in Printer: UP-T80BP– 9 –2. Install the PS+CONTROL PWB 6666.Caution: The power supply unit is an important item. Make sure that theunit

UP-3301V Built-in Printer: UP-T80BP– 10 –9. Install the PAPER GUIDE MMMM to the PRINTER UNIT NNNN.10. Install the thermal HEAD CABLE OOOO to the PRIN

UP-3301V Built-in Printer: UP-T80BP– 11 –13. Connect the Printer cables to the CONTROL PWB.1) SWITCH UNIT CABLE I: Connect to the CN7.3) AUTO CUTTER R

UP-3301V LAN– 12 –1. LIST FOR SCREWs2. INSTALLATION OF THE PAPER NEAR END SENSOR [PARTS LIST]1) Remove the BOTTOM PLATE .2) Remove the PS+CONTROL PWB

UP-3301V CONTACTLESS KEY– 13 –21. CONTACTLESS KEY1) Remove the connector of a clerk key 1, Remove the two screws2, and remove the clerk key unit.Remov

qSHARP CORPORATIONDigital Document Systems GroupProducts Quality Assurance DepartmentYamatokoriyama, Nara 639-1186, Japan2003 July Printed in Japan tC

UP-3301V CAUTIONRISK OF EXPLOSION IF BATTERY IS REPLACEDBY AN INCORRECT TYPE.DISPOSE OF USED BATTERIES ACCORDINGTO THE INSTRUCTIONS.AVOID: SHORT-CIRC

UP-3301V– 1 –Requirements for soldering circuit partsTo solder the following parts manually, follow the conditions describedbelow.Note for handling of

UP-3301V Removing the Rear display filter– 2 – • How to Insert the FFC Connector(1) Open the slider to the unlock positionOpen the slider upwards up t

UP-3301V Removing the Top cabinet– 3 –5. Removing the Top cabinet1) Remove the two Screws 1.2) Remove the Side cabinet 7.3) Remove the Screw 2.4) Remo

UP-3301V Removing the LCD unit– 4 –9. Removing the LCD unit 1) Remove the LCD unit 1.a) Remove the four Screws 2.2) Remove the LCD rear cabinet 3.a) R

UP-3301V Replacing the LCD unit– 5 –5) Remove the LCD M.a) Remove the five Screws N.b) Remove the LCD plate O.c) Remove the LCD PWB unit P.10. Replaci

UP-3301V EFT I/F: ER-02EF2– 6 –13. EFT I/F: ER-02EF21) Remove the rear cover.2) Remove the rear display.3) Remove the screw 1 from the chassis.4) Inse

UP-3301V HOW TO EXTEND DISPLAY POLE– 7 –17. HOW TO EXTEND DISPLAY POLEThe pole can be extended by installing the attached pole to the stan-dard pole.C