Sharp DP-750 Manuale di Servizio Scaricare il pdf (Pagina 43)

WAGO-I/O-SYSTEM 750 Connect Devices 43

750-652 Serial Interface RS-232 / RS-485

Manual

Version 1.3.0

7 Connect Devices

Use shielded signal lines!

Only use shielded signal lines for analog signals and I/O modules which are

equipped with shield clamps. Only then can you ensure that the accuracy and

interference immunity specified for the respective I/O module can be achieved

even in the presence of interference acting on the signal cable.

7.1 Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP

connection is appropriate for solid, stranded and

finely stranded conductors.

Only connect one conductor to each CAGE CLAMP

Only one conductor may be connected to each CAGE CLAMP

Do not connect more than one conductor at one single connection!

If more than one conductor must be routed to one connection, these must be

connected in an up-circuit wiring assembly, for example using WAGO feed-

through terminals.

Exception:

If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to

join the wires together. The following ferrules can be used:

Length: 8 mm

Nominal cross section

max.

: 1 mm

for 2 conductors with 0.5 mm

each

WAGO product: 216-103 or products with comparable properties

1. For opening the CAGE CLAMP

insert the actuating tool into the opening

above the connection.

2. Insert the conductor into the corresponding connection opening.

3. For closing the CAGE CLAMP

simply remove the tool. The conductor is

now clamped firmly in place.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 83 84

Nessun commento

Sharp DP-750 Manuale di Servizio Pagina 43