Sharp JW-20RS Manuale Utente Scaricare il pdf (Pagina 167)

9·69

④ When the communication error occurs instantaneously.

Cause may be:

• Noise on the communication line.

• Fault of a communication module.

• Fault of a communication cable.

Check the error’s timing.

When the error occurs synchronous with a peripheral industrial robot’s operation, noise to the

communication line may be a cause. Consider arrangement of the wiring route.

Identify the error station.

When the error occurs at only the specific station, the cause may be the station or nearby. Check

the following items.

• Setting of the LT (termination resistance) switch.

• Cable (See page 9·64 “check items of cables and connectors”)

• Error code (See page 9·54)

When identification of the cause is difficult.

Condition of the circuit may be unstable. (See page 9·64 “check items of cables and connectors”)

⑤ When the communication error occurs continuously.

Identify the error station.

Specify the error’s station using the communication flag etc., and check this station.

• Check the power of the error’s station.

• Check the error code of the error’s station.

• Check cables near the error’s station. (See page 9·64 “check items of cables and connectors”)

When identification of the cause is difficult.

Condition of the whole circuit may be unstable. Check cables and connectors.

(See page 9·64 “check items of cables and connectors”)

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 229 230

Nessun commento

Sharp JW-20RS Manuale Utente Pagina 167